L Stainless Steel Sheet. ASTM A Characteristics. / L stainless steel sheet exhibits high strength, toughness and high temperature resistance. The following alloys meet the ASTM-A standard. Select an alloy for product specifications: stainless steel provides high strength and good ductility. ASTM A Standard Specification for Annealed or Cold-Worked _机械 /仪表_工程科技_专业资料。ASTM A Standard.
|Country:||Central African Republic|
|Published (Last):||23 February 2008|
|PDF File Size:||16.59 Mb|
|ePub File Size:||19.7 Mb|
|Price:||Free* [*Free Regsitration Required]|
If you feel that your comments have not received a fair hearing you should make your views known to the ASTM Committee on Standards, at the address shown below. Your comments are invited either for revision of this standard or for additional standards and should be addressed to Sstm International Headquarters. Only annealed conditions of grades specifically approved by the ASME code are permitted for pressure vessel use. B Maximum unless otherwise indicated. C Annealed material that naturally meets mechanical properties may be applied.
Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility.
A — 03 Standard Speci? Specimens shall be bent around a diameter equal to the product of the bend factor times the speci?
ASTM does not give any warranty express or implied or make any representation that the contents of this a666 are accurate, complete or up to date. Individual reprints single or multiple copies of this standard may be obtained by contacting ASTM at the above address or at phonefaxor service astm. B Type is generally produced with a chemical composition balanced for rich side Type or lean side Type austenite stability depending on the properties required for speci?
This standard has been approved for use by agencies of the Department of Defense. Historical Version s – view previous versions of standard. Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend.
ASTM A for Annealed or Cold-Worked Austenitic Stainless Steel Sheet, Strip, Plate, and Flat Bar
This specification covers austenitic stainless steels in the annealed and normally required cold-worked conditions. The specimens shall asttm subjected to tension test, free-bend test, and controlled-bend or V-block test. Current edition approved Oct.
They shall be formed in different shapes such as sheets, strips, plates and flat bars. Depending on the work hardening characteristics of the particular grade, either the yield or the tensile strength can be the controlling factor in meeting the properties.
This revision of Speci? Material Test Report and Certi?
ASTM A666 for Annealed or Cold-Worked Austenitic Stainless Steel Sheet, Strip, Plate, and Flat Bar
The values given in parentheses are for information only. The noncontrolling factor normally will exceed considerably the speci?
ASTM International takes no position respecting the validity of any patent rights asserted in connection with any item mentioned in this standard. Link to Active This link will always route to the current Active version of the standard.
Only annealed conditions of grades speci? ICS Number Code This abstract is a brief summary of astk referenced standard. The values obtained in this manner should not, however, be taken as the actual yield strength for 0.
Hard Elongation in 2 in. A superscript epsilon e indicates an editorial change since the last revision or reapproval. One bend test shall be made from one end of each coil.
ASTM-A Alloys | E. Jordan Brookes Company
A number in parentheses indicates the year of last reapproval. Last previous edition approved in as A — Mechanical q666 such as yield strength, tensile strength, elongation, hardness, and bending shall be determined. The steels shall adhere to specified chemical composition requirements. The values given in parentheses are for information only.
An alternative method of determining? In case of dispute, the offset method of determining yield strength shall be used.
Rockwell B 95 95